Flat Roofing in Wilmington from $5. $5 to $14 a square foot, and in this climate the snow load decides the detail. Free inspection and a written quote.
Post-war attached garages and rear additions, generally large and easy to reach, which keeps this work cheap and predictable. The fault to watch for is a wide area built dead level, which will pond however good the membrane is.
Flat roofing installs at $5 to $14 per square foot: EPDM at $5 to $9 and TPO at $6 to $12 across normal residential work. Most of it here is an ell, a porch roof, a dormer top or a garage sitting beside a pitched roof and draining onto or through it.



Flat roofing installs at $5 to $14 per square foot: EPDM at $5 to $9 and TPO at $6 to $12. What is different here is winter -- a low-slope roof carries load for weeks rather than hours, and meltwater runs beneath the snowpack rather than off it. The most predictable pricing here. Simple shapes and good access mean the variables are visible: the layer count, and whether you are being quoted architectural at $6.75 to $11.50 or three-tab nearer $3.50 for a similar-looking total.
A simple rectangle with a real fall, at accessible height, draining somewhere sensible. Most post-war garages and rear additions qualify.
Junctions and parapets. Where a low-slope roof meets a wall the upstand has to clear the snow that will sit against it, and on an older house that junction is often between two things built a century apart.
An outlet that freezes is an outlet that is not there. Drainage sized and sited for meltwater rather than a summer downpour is what separates a membrane that lasts from one tested at every seam.
The most straightforward roofing in this service area and the easiest to price honestly: moderate pitches, good access, little geometry. The variables are age and layer count, and two coverings is the ceiling before a tear-off stops being optional.
Simple roofs are where the difference between an architectural and a three-tab quote shows up most plainly, because nothing else in the price is complicated.
The first two are free, checkable, and worth $25,000 between them.
The answer should be the contractor, without hesitation. If somebody suggests you pull it because you are the owner, they are asking you to give up your recourse under c. 142A to save an afternoon.
Nobody knows how much deck has softened until the covering is off. A rate per sheet is honest; a lump sum gets revisited upwards once the roof is open.
If the roof has been damming, the covering was probably not the cause. A quote that replaces shingles and says nothing about the roof space is quoting for the symptom.
The most straightforward replacement work in this service area -- moderate pitches, good access, little geometry.
Simple roofs fail simply, which is good news for a repair: a lifted course, a split pipe boot, a nail line backing out.
Streets of similar post-war houses give a useful test: if some dam and others do not, the roofs are the same, so the difference is what has been done inside them since.
Post-war houses here were mostly built for asphalt, so cedar is a deliberate upgrade rather than a restoration.
On simple post-war roofs an inspection answers two questions quickly: how many coverings are up there and how much life the top one has left.
We pull the permit. That is what keeps you eligible.
Lakeside and Victorian. Details, not area.
Big simple roofs under a lot of trees.
Large houses, complicated roofs, real cedar country.
Hilly, tight, and full of capes with rooms in the roof.
A city: every building type within one mile.
What is worth knowing before you book this.
Not in itself -- water that clears within a day or two of rain is normal. Water still there a week later is a seam being tested continuously. In winter it is worse, because ice over an outlet means the roof has no drainage at all until it thaws.
EPDM at $5 to $9 a square foot and TPO at $6 to $12, and on normal residential additions either will do if the detailing is right. What matters far more here is upstand height and drainage, because both have to work with snow sitting on the roof rather than rain running off it.
Rarely the full term in this climate. The rating describes the material under test conditions, not a roof on a particular house north of Boston. What shortens it here is the melt-refreeze cycle at the eaves, roof space ventilation, and how well the thing was nailed on day one. A 30 year product commonly gives 20 to 25 real years here, and a roof with proper ice barrier coverage and a working ventilation path will beat one without by several of them.
For a standard asphalt roof on an average house, it is at the top of the range -- most Greater Boston single-family replacements land at $12,000 to $22,000. It is entirely reasonable for a large or steeply pitched house, a roof with a lot of dormers and valleys, or cedar shake at $12 to $20 a square foot. The number alone does not answer the question; what the quote itemizes does. If it does not break out area, tear-off, decking and the ice barrier, no figure can be judged.
It is a Florida rule and it has no force in Massachusetts. The 25% rule comes from the Florida Building Code Existing Building, where repairing or replacing more than a quarter of a roof within a year can require the whole roof to be brought up to current code. Massachusetts has no equivalent provision -- what governs here is the state building code and your own municipality's permitting. It turns up in searches because national content repeats it without saying which state it belongs to.
The HIC registration number on the paperwork, not just a website. A written contract, as this state requires over $1,000.